Supported Audio File Formats for SpitFire
There are basically 2 different configurations of Windows PCM Wav files that SpitFire software supports. For all analog cards and T1 cards using a Flat (D4 AMI) T1: Sample Rate: 8000 Hz (8 kHz) Data Rate: 16 bit Channels: Mono For all PRI and SIP trunks or Dialers using Text to Speech: Sample R ...
- PRI Provisioning
PRI Settings B8ZS B8ZS is an abbreviation for bipolar with eight-zero substitution. A method of line coding used in the T-carrier system which allows full 64 kbit/s per second per channel. ESF T-1 carrier framing format that provides 64kb clear channel capability, error checking, 16-state ...
- T1 Crossover Cable
Pinout View Facing Cable End 12 34 5678 Cable End A 45 31 2678 Cable End B So in this diagram we can see that Pin 1 is connecting to Pin 4 and Pin 2 is connecting to Pin 5. To make a T1 crossover cable you will need an RJ45 crimping tool and at least one RJ45 end. Although s ...
- Testing PRI Lines with ISDIAG
To test channel 1 on the first card isdiag 1 1 t s To test channel 1 on 2nd card isdiag 2 1 t s 6 to dial the number and 5 to hangup the call. You must use the hang up command from this window to disconnect the line correctly. Alternate Dialing method for PRI Enter the number and then press En ...
- Line Testing with Dialogic Multi-Threaded Voice
Dialogic Multi-Threaded Voice is an application that can be used for testing phone lines individually, without using any SpitFire software settings. It can be used for testing analog or digital, Flat T1 lines but not PRI T1 lines. Note: See this article for using ISDIAG to test PRI lines throug ...
- Flat T1 Provisioning
Model Number D240SC-T1, D/240PCI-T1 Framing Type D4 Super frame (not extended SuperFrame) Interface DSX-1 T-1 Signaling Robbed bit Supervisory Signal 2- or 4- wire E&M Timing Loop timing Internal Clock Stratum Level Stratum 4 T-Span support Full (24 timeslots) Voice coding PCM Channel order 1 ...
- Installation Instructions for CTI32
CTI32 Installation Instructions 1)Install Dialogic 5.1.1 along with service pack 1. 2)In Dialogic Configuration Manager (DCM), right click on the first board and go to Configure Device option. 3)Go to Interface tab and choose the correct ISDNProtocol (this information must be provided by the ...
- Fixing Issue with Operator Intercept detection in CTI32
This can manifest itself as the dialer detecting OI's as No Answers for PRI T1's. In order to fix this issue, in the cti32.ini file add this parameter to [General] section: ProgressingLogic=1
- Cyclic Redundancy Check (CRC6) for PRI
Occasionally, a circuit will need this parameter to be enabled on the Dialogic card software so that it will not reset itself and loose connection. To avoid this situation CRC check needs to be enabled in the parameter (.prm) file. The content that needs to be added can be placed anywhere in the ...
