Flat T1 Provisioning
Model Number
D240SC-T1, D/240PCI-T1
Framing Type
D4 Super frame (not extended SuperFrame)
Interface
DSX-1
T-1 Signaling
Robbed bit
Supe...
- PRI Provisioning
PRI Settings
B8ZS
B8ZS is an abbreviation for bipolar with eight-zero substitution.
A method of line coding used in the T-carrier system which allows full 64 kbit/s...
- Testing PRI Lines with ISDIAG
To test channel 1 on the first card isdiag 1 1 t s To test channel 1 on 2nd card isdiag 2 1 t s
6 to dial the number and 5 to hangup the call. You must use the hang up command from this windo...
- Cyclic Redundancy Check (CRC6) for PRI
Occasionally, a circuit will need this parameter to be enabled on the Dialogic card software so that it will not reset itself and loose connection. To avoid this situation CRC check needs to be enable...
- Fixing Issue with Operator Intercept detection in CTI32
This can manifest itself as the dialer detecting OI's as No Answers for PRI T1's. In order to fix this issue, in the cti32.ini file add this parameter to [General] section:
ProgressingLogic=1
- Installation Instructions for CTI32
CTI32 Installation Instructions
1)Install Dialogic 5.1.1 along with service pack 1.
2)In Dialogic Configuration Manager (DCM), right click on the first board and go to Configure Device opt...
- T1 Crossover Cable
Pinout View Facing Cable End 12 34 5678 Cable End A 45 31 2678 Cable End B
So in this diagram we can see that Pin 1 is connecting to Pin 4 and Pin 2 is connecting to Pin 5. To...
- Line Testing with Dialogic Multi-Threaded Voice
Dialogic Multi-Threaded Voice is an application that can be used for testing phone lines individually, without using any SpitFire software settings. It can be used for testing analog or digital, Flat ...
- Supported Audio File Formats for SpitFire
There are basically 2 different configurations of Windows PCM Wav files that SpitFire software supports. For all analog cards and T1 cards using a Flat (D4 AMI) T1: Sample Rate: 8000 Hz (8 kHz) Da...